Dynamic Seam Fatigue Tester
Summary:
The seam Fatigue Tester is applied to determine the strength of upholstery seam constructions which are covered by a standard foam composite cushion by imposing a cyclic, impact, and penetrating load. Dynamic Seam Fatigue Tester complies with ASTM D4033, etc.
Seam Fatigue Tester is the measurement of failures in the three most commonly used upholstery seams - warp sewn to warp (wale to wale), filling sewn to filling (course to course), and warp sewn to filling (wale to course).
Standards:
ASTM D4033 etc.
Principle:
Fix a seamed sample on a sample holder containing an elastic foam pad, fix both sides, and use a fixed-weight, freely rotating rubber-surfaced wheel to continuously impact the sample surface from a certain height. , until the set number of times, check whether the seam of the sample is damaged.
Application
Dynamic Seam Fatigue Tester is specially designed to test the strength of upholstery seam constructions which are covered by standard foam composite cushions by imposing a cyclic, impact, and penetrating load. Dynamic Seam Fatigue Tester enjoys a wide application in many industries, such as automobiles, garments, and fabrics.
A rubber-faced wheel of 127mm (5”) diameter impacts the fabric from a height of 150mm (6”) with a mass of 3.75 kg (8.25lbs), 25 times per minute for 7000 cycles. Besides, the Dynamic Seam Fatigue Tester has 3 work positions and 6 positions complying with the requirement. Moreover, it can make 23 or 27 cycles in one minute. Thus, it can be in operation at a relatively high speed.
Specification
Model number
DZ-379
Test position
3
Drive mode
Cylinder drive
Impact speed
(0.4±0.03)Hz, (25±2)cycles/min
Testing times
7 000cycles
Impact wheel mass
3.75kg (8.25LB)
Dropping height
150 mm (6 in.)
Testing sample
190mmx255mm
Power supply
1∮AC 220V 50/60HZ
Dimensions
160x90x145cm
Weight
150kg
Standards
ASTM D4033
Accessories
Standards accessories
1set
Fixture
1pc
Air pipe
1pc
Power line
Optional accessories
Optional
Air compressor
Model number |
DZ-379 |
Test position |
3 |
Drive mode |
Cylinder drive |
Impact speed |
(0.4±0.03)Hz, (25±2)cycles/min |
Testing times |
7 000cycles |
Impact wheel mass |
3.75kg (8.25LB) |
Dropping height |
150 mm (6 in.) |
Testing sample |
190mmx255mm |
Power supply |
1∮AC 220V 50/60HZ |
Dimensions |
160x90x145cm |
Weight |
150kg |
Standards |
ASTM D4033 |
Accessories
Standards accessories |
1set |
Fixture |
|
1pc |
Air pipe |
|
1pc |
Power line |
Optional accessories |
Optional |
Air compressor |